Útmutató

What Is a Bump Key? How Lock Bumping Works and Which Locks Resist It

One filed key blank, one tap, and a standard cylinder opens. Here is why it works, why it fails against security pins, and how to tell which kind you have at home.

Updated 28 September 2026 · Security · 9 min read

A bump key is the attack that unsettles people most: no picking skill, no damage, and a key blank anyone can file. It is also the attack that a decent lock shrugs off completely. This guide explains the physics, the locks it beats, the locks it cannot touch, and how to work out in two minutes which kind is in your own door.

What is a bump key?

A bump key is an ordinary key blank for a given keyway, with every cut filed down to the deepest position the manufacturer uses — position 9 on most systems, which is why pickers also call it a 999 key. It fits the lock, it turns nothing on its own, and it looks like a key that has simply been cut badly.

What makes it work is not the shape but the impact. The key is inserted, pulled back one notch, given light turning pressure, and struck — with a screwdriver handle, a rubber mallet, the heel of a hand. The blow travels through the key into the pin stacks, and for a few milliseconds every driver pin jumps clear of the shear line. If your turning pressure is right at that instant, the plug rotates and the lock is open.

The short version: a bump key is a key blank cut to its deepest position, used as a hammer rather than as a key. It defeats standard pin tumbler locks in seconds and does essentially nothing against spool pins, serrated pins, sidebars or disc detainers. Which group your own lock belongs to is the only question that matters — and you can answer it without buying anything.

How lock bumping works: the physics

Every pin tumbler lock holds its plug still with stacks of two pins: a key pin at the bottom and a driver pin above it, pressed down by a spring so the driver bridges the shear line.

A deeply cut bump key sits below every key pin. When you strike the key, each ramp on the blade slams into its key pin and transfers the energy upward — the same transfer you see in a Newton's cradle. The key pin barely moves; the driver pin flies up, clears the shear line, and hangs in the air for a few milliseconds before the spring pulls it back.

That gap is the whole attack. Hold very light rotational pressure and the plug turns into the gap the instant the drivers are above the line. Hold too much pressure and the drivers bind against the plug instead of flying; hold none and the drivers fall straight back. Bumping fails far more often for bad tension than for bad keys — exactly like picking with a bobby pin.

A pick gun does the same job mechanically: a needle under the key pins, a spring-loaded strike, the same bounce. If you have ever watched a snap gun open a cheap padlock, you have already seen lock bumping.

Do bump keys actually open locks?

On the right lock, yes — in under five seconds, with no marks that a locksmith could distinguish from normal wear. That is precisely why the technique caused alarm when Dutch and German locksport groups demonstrated it publicly in the mid-2000s, and why European manufacturers have had two decades to respond.

The honest answer today has three parts:

  • Standard-pinned cylinders: yes. Unbranded euro cylinders that came with a door, old rim cylinders, most cheap padlocks, a large share of North American residential locks.
  • Branded European cylinders sold in the last decade: usually not. Anti-bump pinning, spool and serrated drivers, and sidebars are now standard even in mid-range ranges.
  • Anything without spring-loaded pin stacks: never. A disc detainer has no springs to exploit; a lever lock has no pins at all.

There is one more limit that gets ignored: a bump key is keyway-specific. It has to be filed from a blank that physically enters your lock. The "bump keys for all locks" sets sold online are a handful of common profiles, not a master solution — and on a restricted profile, no blank means no attack.

Which locks resist bumping?

Anything that breaks the Newton's-cradle chain or punishes the plug for turning early:

Defence How it stops a bump Where you find it
Spool and serrated driver pins The driver false-sets in its waist instead of clearing the line; the plug jams Most branded cylinders and mid-range padlocks
Anti-bump pinning Mixed pin weights and spring tensions so the stacks do not bounce together ABUS, ASSA, EVVA, Kaba, Iseo, Gerda and similar
Sidebar A second locking element the pins do not control High-security systems, many car locks
Disc detainer Rotating discs, no springs — nothing to bounce Abloy, ABUS Granit, quality bike locks
Lever locks No pin stacks at all British mortice locks, safes, older European doors
Restricted keyway No blank available to file Patented profiles with a security card

Spool pins are the workhorse defence, and they are the same feature that makes a lock interesting to pick. If you want to feel why bumping stops at a spool, that is the subject of our guide to security pins, false sets and counter-rotation.

Bump key vs picking vs pick gun

Bump key

Fast, cheap, keyway-specific, useless against security pins. No skill curve, no feedback, no way to adapt when it fails — you either have the right blank against the right lock or you do not.

Single pin picking

Slow, skilled, works on almost everything eventually because you read each pin individually. This is the actual hobby, and the reason the belt ranking measures picking rather than bumping.

Pick gun

Bumping without the key: a needle does the striking, so one tool covers any keyway it fits. Same strengths, same hard ceiling at the first spool pin.

Manual Lock Pick Gun (Snap Gun) with Needles
The hobby version of the same physics · €24.9Manual Lock Pick Gun (Snap Gun) with Needles

If the physics of bumping is what interests you, this is the legitimate way to explore it: a snap gun applies the same impulse through a needle instead of a filed key, on locks you own, with no keyway-specific blank involved. Adjustable spring, straight and curved needles, tension wrench included — and a useful reality check, because it will stop dead at the first spool pin.

See the product

How to check your own lock in two minutes

No tools, no purchase:

  1. Look for a brand. An unmarked cylinder that came with the door almost certainly has plain driver pins. A name you recognise almost certainly does not.
  2. Look for a certification mark. UK: TS007 3-star or SS312 Diamond. Poland: klasa C under PN-EN 1303. Germany: DIN 18252 / VdS. These are tested, unlike the word "security" printed on a blister pack.
  3. Look at your key. Dimples, a side groove or a wavy track instead of a plain jagged edge usually means a sidebar or a restricted profile — both of which end the bumping conversation.
  4. Try to have a copy cut. If a kiosk cannot copy it without a security card, no one can file a blank for it either.

If all four answers point the wrong way, a replacement cylinder from a known brand costs less than a takeaway for two and takes one screwdriver and five minutes. That single upgrade closes bumping, most picking and — if you choose an anti-snap cylinder — the attack that actually happens to European doors.

In most of Europe a bump key is treated exactly like a lock pick: the tool is not the offence, using it on someone else's lock is. Germany, Austria, the Netherlands, Czechia and the Nordic countries regulate the act, not the object. Finland requires an acceptable reason for possessing burglary tools. The UK restricts carrying them under "going equipped". Poland is the exception: art. 129 of the Code of Petty Offences penalises making, possessing or acquiring picks unless your profession requires them, and a filed bump key falls squarely in that description.

The country-by-country detail, with the actual statutes, is on our legality page. Practice locks — transparent padlocks, cutaway cylinders — are not tools of entry and are unrestricted everywhere we ship.

Why we do not sell bump keys

We sell picks, practice locks and pick guns, so this is not squeamishness. It is that a bump key is the one tool in this field with no learning value whatsoever. It teaches nothing about binding order, tension or feedback; it works on exactly the locks that were never secure; and unlike a pick, it is cut for one specific keyway that is far more likely to be a real door than a practice lock on a desk.

If the physics interests you, a pick gun gives you the same impulse on your own locks and a transparent lock lets you watch the drivers jump. If the security question interests you, the two minutes above are worth more than any tool.

Frequently asked questions

Do bump keys really work?

On locks with plain driver pins, yes — often in seconds. On cylinders with spool or serrated pins, anti-bump pinning, a sidebar or no springs at all (disc detainer, lever locks), generally not. Most branded European cylinders sold in the last decade resist bumping.

What does a bump key look like?

Like a badly cut key. It is a normal blank for that keyway with every cut filed to the deepest position, which gives it an even row of sharp peaks instead of the irregular profile of a real key.

Does lock bumping damage the lock?

Usually not visibly, which is part of why it worries people. Repeated bumping does burnish the pins and can chip a plug edge over time, but a single bump rarely leaves evidence a locksmith could separate from normal wear.

Is a bump key the same as a pick gun?

The principle is identical — a sharp impulse that throws the driver pins above the shear line. A bump key does it with a filed blank that must match the keyway; a pick gun does it with a needle and fits any keyway it enters.

How do I bump-proof my front door?

Fit a branded cylinder with security pins and anti-bump pinning, check it does not protrude more than 3 mm past the handle plate, and look for a tested mark (TS007 3-star, SS312 Diamond, klasa C, VdS). That combination also handles picking and snapping.

Can you bump a padlock?

Cheap pin tumbler padlocks, yes. Padlocks with spool pins, ball-bearing shackle locking or a disc detainer core, no. A cheap padlock usually fails to a shim long before anyone bothers filing a key for it.

Next step: see why a spool pin stops all of this in security pins explained, or read the full picture of what really opens a European door in how secure is your door lock.

Written by the Lockpit Kit teamWe pick every practice lock we list, grade it against the community belt ranking and write the guide that ships in the box. Everything here comes from that bench work and from the public sources linked in the article. Only pick locks you own — see legality by country.

Olvass tovább